|
|
All items are located in Maricopa, AZ Call 520-568-3511
Rear engine dragster - $12000
205 inch rear engine dragster as shown in pictures or we can finish, engine, trans, paint.
|
 |
 |
 |
|
Keller Mechanical Hacksaw
Don't do it by hand. Let this saw cut while you do something else. Keller reciprocating hack saw will get that job done. Will cut large pieces of metal.
$600
|
383 SBC Performance Engine
Has not been ran since assembled, 4.030 bore, 3.750 stroke, 12:1 comp. titanium valves, balanced.
$6000.00
Also have transmission, clutch, headers, exhaust system and more.
If you are working of a project car and need pieces and parts we can help you. We have a 383 96 Corvette performance engine, 6 speed manual transmission with clutch & aluminum flywheel , exhaust system, headers and more.
$7500.00
Stock 454 Chevrolet long block - we just need to assemble.
$1100
|
|
|
 |
|
1978 El Camimo, was running, but engine and transmission used in another project. Now have 350 engine ready to assemble and 350 transmission to install. . All parts are there. Nice body. good glass. Interior needs work. New AC parts/compressor.
$1800.00
|
2000 Dodge van, 3.0 litre V6 engine, 5 doors, new tires, dash mat, daily driver, good body, needs paint.
$3,000
|
|
 |
 |
|
Good working L-Tec Heliarc Welder with water cooling tower and bottle.
$1500.00
|
Make your own parts with a True Trace tracer mill Traces around a pattern and cuts it out of metal. This is a freestanding machine, no other mill required
$750.00
|
|
 |
 |
|
67 chevelle street/strip project car.
Garaged
Have everything except the original hood
Was a 283 glide car and from Arizona - No Rust!
Stock rear is cut out for a narrowed 9-inch with ladder bars. Lincoln rear with disc brakes and Moser 31 spline axles, detroit locker w/ 4.30 gears. Has koni double adj. coil overs. Also has a 10 point cage but got as far as installing it to a 4 point so far.
Wanted to install the top hoop and front pillar bars and realized the base of windshield was rotted away and started in on the dash a little so I took out the glass and dash to fix the problem. Thats where I'm at with it. I can finish or ?????? like I said the only un-repairable stuff done to this car is no stock rear suspension and I cut out a muffler sized hole in the floor behind the seats on each side. The dash will go back in just fine as the damage to it was minimal plus it makes it easier to install the pillar bars. have lots of stuff for this ride.
$8500
|
|
|